Follow

GNSS Correction Compatibility

Please check back with this list as we will attempt to update it as we get additional information about hardware & firmware combinations that support GNSS operations with RTCM version 3.2 MSM (Multi Signal Message).  We are leaving this Knowledge Base Article open for comments so users can also provide additional feedback or working combinations.

If in doubt about compatibility, please check with your hardware & software vendor to make sure you have the correct activations, codes, firmware and software.  Also, please note, due to the high degree of variability in build dates & receiver variants on the market this list is not to be considered absolute.

If you log into SmartNet and you see any of your constellations drop, this is not a severe issue.  This simply means the station you are connected to is either not fixed on a particular constellation or currently is not activated for that constellation.  Over the next 30-60 days this is expected and there is no need to create a support ticket.  After October 1, 2017 if you are one of the markets listed below, please let us know if you experience drops of entire constellations.

Leica Geosystems GNSS Receivers

Product SW / FW Version GNSS Compatibility
GS16 SmartWorx Viva 6.15+ GPS (Incl L5), GLO, GAL, BEI 
GS15 SmartWorx Viva 6.15+ GPS (Incl L5), GLO, GAL, BEI
GS14 SmartWorx Viva 6.15+ GPS, GLO, GAL, BEI
iCON iCG60 GNSS   GPS (Incl L5), GLO, GAL, BEI 
Zeno 20   GPS, GLO, GAL E1, BEI B1
Zeno GG04   GPS (Incl L5), GLO, GAL, BEI

 

Spectra Precision GNSS Receivers

Product SW / FW Version GNSS Compatibility
SP80 GNSS V 3.36 GPS, GLO, GAL, BEI 

 

Topcon GNSS Receivers

Product SW / FW Version GNSS Compatibility
GR-5 Unknown GPS, GLO, GAL, BEI 
HiPer HR Unknown GPS, GLO, GAL, BEI

 

Trimble GNSS Receivers

Product SW / FW Version GNSS Compatibility
R10 Access 2015.10+, FW 5.0+ GPS (Incl L5), GLO, GAL, BEI 
R8s Access 2015.10+, FW 5.0+ GPS, GLO, GAL, BEI
R2 Access 2015.10+, FW 5.0+ GPS, GLO, GAL, BEI

*There is a known issue with Trimble receivers being driven by Spectra Survey Pro.  This is an issue that is to be addressed in Survey Pro. Support was never added for RTCM 3.2 MSM inputs/outputs in the Trimble driver.

For additional information about SmartNet GNSS Correction Services, please watch our Summer Update & GNSS Launch Webinar - LINK

Updated 2/11/2019

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk